#MAXEL TRANSFORMER F30C DRIVER#

There was bits of red grease around drag washers. Slide out shaft and rear drag plate as an assemblyĪnd drag washer (key 940) you can see I'm cheating here Turn spool over and remove 4 small screws and cover (key 913) Remove anti reverse ratchet spool ring as a unit All non-exposed surfaces are now coated in marine grade greaseīearing (key 793) greased and back in drag tension knob od 11 id 4 x 4 There seems to be a spray type protectant coating on all internals. Shields have been removed from bearings packed with grease screws backed out and threads greased Repacked bearing going in and notice the antireverse bearing still in housing Right side plate bearing (key 791) 10od 5id x4 Showing drive shaft coat washer (key 680) and bearing (key 384) 15od 10id x4 Remove handle washer (key 661) very tight fit Prevent water intrusion? I have read that there is important service points to the handle I will go through this at a later date Remove anti loose screw (key 779) and fixed nut (767) Showing drag tension Knob and preprogram cam (key 649 646)

#MAXEL TRANSFORMER F30C DRIVER#

I used an insulated electrician's screwdriver as the handle rotates it traps against driver shaft and aids in 'cracking' the screw NB Mark direction of line on spool to aid in reassembly Tighten drag and hold handle to remove Spool shaft screw (key 933) Undo side plate screws using t5 driver (tool provided) Tested way above max drag using my methods There has been a lot of talk about similarities between Maxel and Jigging master Sold in New Zealand with a 5 year warranty

Maxel transformer f30c